![]() MoCA 1.1 compliant A/V splitter 6-way to connect home-run coax to set-top boxes.Ĭall Verizon to switch from coax WAN to Ethernet WAN port, on ONT. I therefore figured I’d share, so others with similar setups can benefit. Finally, after about a week of tooling around, I got everything working and am enjoying full Gigabit service. Also, the Actiontec documentation is extremely sparse. I’m a tech professional, but was not previously familiar with the MoCA specs, so this required some exhaustive searches for information on the web, as well as some trial and error.Īfter ER a few attempts, I managed to establish the Ethernet bridge using the Actiontec devices, but the link was unstable and would also impact the FIOS STBs that also connect via coax. Before giving up, and reverting back to my 100/100 coax-connected plan, I figured I’d give it a whirl, myself. Unfortunately, the techs were unfamiliar with this device, and were unable to establish a WAN link using them. I purchased a pair of the Actiontec ECB6200 MoCA adapters, and figured the on-site Verizon techs could figure this out, since the network topology seemed pretty straightforward.at least, to me. Unfortunately, I do not have Ethernet home-run from the ONT to the basement, so began to explore the use of bonded 2.0 MoCA adapters to service the Gigabit feed from the ONT’s Ethernet WAN port to my G1100 via the existing coax run. Still not enough to support Gigabit service, but greater than 100/100. Of course, 100/100 is the maximum that Verizon will deliver over coax, even though the MoCA 2.0 protocol in the G1100 supports up to 500 mbps. A Verizon G1100 router in the basement took the MoCA WAN signal and bridged it to my Ethernet network connected to a separate switch. Under the 100/100 plan, the WAN connection to the ONT was delivered over my home-run coax line from the garage to the basement. While the ONT is in my garage, all of my coax and Ethernet connections are home-run to the basement. I recently switched to a 100/100 FIOS plan to Gigabit. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |